Look for IT over here

There is probably only one reason why you would want to take apart your Linksys wireless router - you have bricked it due to a bad firmware flash (or something very similar).

I decided to write some instructions to go with my other article on unbricking the V5. I noticed, looking at the stats for this site, that the majority of visits were for this post. As I said in that article, I could not find (at that time) any info on how to fixed a bricked V5.

These instructions will not only apply for the V5, but the earlier Linksys wireless routers as well.

Continue Reading »
Disassemble Linksys WRT54g V5

I decided to share my experiences below on how to unbrick my Linksys WRT54G V5 wireless router - it was bricked after I had a problem (after) installing open source firmware, and I could not find specific instructions for the V5. Having nothing to lose, as it wasn’t working, I followed similar instructions for the V4 series.

I have a couple of wireless routers at home. Having heard so much about the Linksys WRT54G being a good router to run open source firmware, I decided to buy one.

The firmware I put on it was DD-WRT . It has a good user base and support, and being easy to use I was quiet happy with it.

Then the fun started. Somehow, the power plug for the router was not sitting in the power point properly, so the unit was powering off/on in succession. Then the unit would not boot up. The power LED was flashing, and the port LEDs were not coming on when I plugged the Cat5 cables into them.

Oh no, have I ‘bricked’ the Linksys - two days after I have bought it? I did a bit of searching around and All the info I could find was for earlier model WRT54G routers that use a intel chip. The V5 does not.

Continue Reading »
Unbrick your WRT54G V5